Specification for high expansion heat-resisting steel bar and wire for the manufacture of bolts, studs, set screws and nuts (Ni 25.5, Cr 15, Ti 2, Mn 1.5, Mo 1.25, Si 0.7, V 0.3) (limiting ruling section 50 mm) Ingestion-build-225643 BS IEC 60092-509 focuses on

BS IEC 60092-509 focuses on electrical installations in ships

- a seal status identification system

Identifying interoperable combinations of subsystems

Why should you use BS EN 969 - Requirements and test methods for gas pipelines

operating at rates of 100 kilobits/second or less

Specification for high expansion heat-resisting steel bar and wire for the manufacture of bolts, studs, set screws and nuts (Ni 25.5, Cr 15, Ti 2, Mn 1.5, Mo 1.25, Si 0.7, V 0.3) (limiting ruling section 50 mm) Ingestion-build-225643 BS IEC 60092-509 focuses on1 Scope This British Standard specifies requirements for high expansion heat resisting steel bar and wire in the following forms for the manufacture of bolts, studs, set screws and nuts. a) Bar with a diameter over 25 mm up to and including 50 mm and wire with a maximum diameter of 50 mm for machining: softened, cold worked, solution treated and machined or ground, designation HR 650A. b) Bar with a diameter over 25 mm up to and including 50 mm and