3/4" - 1" PVC Push Cap Compression Points

3/4" - 1" PVC Push Cap Compression PointsThe push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed. The push point is connected to the front or leading end of the pipe and the push cap is inserted into the opposite end of the same pipe. Once in place, the push cap may be struck with a hammer to drive the pipe past the obstruction and on to the other side. NOTE: This part is rarely used but in the case of pockets of gravel

The rig itself attaches to the sidewalk and does not require that  stakes or anchoring devices be driven into the property owners soil next to the sidewalk

Kit includes:

1) The compression point is removed in the exit pit

Insert an allan wrench into one hole untill it seats in the allan screw on the opposite side of the hole in the point

The push point is connected to the front or leading end of the pipe and the push cap is inserted into the bell housing on the opposite end of the same pipe

Connect the hook to the extraction chain

As it advances It will chase the hole and push back out of the way any roots

QR Code with link to instructional video

Drop a 2x6x8 board with pre-drilled

Female thread cleaning brush

It is threaded into the end of a 2” sch 40 PVC pipe or conduit

Remove the point