Plastics pipes and fittings. Determination of opacity Ingestion-build-266356 Why should you use BS

Why should you use BS 2782-6:Method 621C - Bulk factor of molding materials

BS EN 17161 promotes accessibility following a Design for All approach in mainstream products

3 Calibration of particle count response

enabling the structural integrity and stability of chemical stores

The nominal pressure is up to 28000 kPa

Plastics pipes and fittings. Determination of opacity Ingestion-build-266356 Why should you use BS1 Scope This International Standard specifies a method for the determination of the opacity of plastics pipes and fittings. Annex A gives guidance on the light transmission of opaque pipes and fittings. NOTE It is necessary for a pipe or fitting used for water supply which is exposed to visible light during service to be sufficiently opaque to prevent algae growth.